      
|
CLICK LOGOS BELOW
|
Genesis Soil Rite Calcium is a proprietary blend of lime, limestone and all natural minerals, herbs and spices for your soil. Genesis Soil Rite Calcium is only calcium. We are not calcium carbonate, calcium sulfate, or calcium chloride. We do not have baggage. DORMANT GSR CALCIUM Our dormant product is applied after harvest and prior to the first freeze. It works while the soil is sleeping or lying dormant. Key places to use this are high magnesium soils, high potassium soils, as well as alkaline soils. Why should GSR Dormant Calcium be applied? GSR Dormant was designed to work on the soil conditions which cause the problems. An imbalance or excess amount of nutrients such as salt, sodium, potassium, magnesium or sulfur generally causes most problems, including lack of water penetration, pH that is too high or too low, excessive lumps, clumps, or clods. What are the best times and condition for application? For best results, apply to exposed bare dirt after growing season and fall tillage – October through to February. GROW GSR CALCIUM Our Grow product is applied after right before or during crop planting. It works while the soil is waking and ready to grow. Why should GSR Growing Calcium be applied? GSR Grow is best applied when available Calcium levels indicate a deficiency. What are the best application times and conditions? It is best applied before, during or after planting. Throughout the season, topical soil applications should be made after tillage; exposed bare dirt is best. MIXING INSTRUCTIONS FOR GSR CALCIUM Minimum Rate of 10 Gallons of Clean Water Per Acre. The More water the better, as GSR Calcium MUST make contact with the soil! * Please note: GSR Calcium DOES NOT tank mix with carbon products such as fulvic acid or humates. Mixing Directions: 1. Use clean mixing equipment, water and sprayer tank. 2. Ensure your water has a pH of less then 7.5. The closer to neutral the better. If pH of the water is high, try using cider vinegar, or household vinegar to reduce the pH. Avoid water sources with excess minerals as this can cause complications with mixing. 3. Make a slurry with the calcium in a smaller container before adding to the sprayer tank. Ensure the product is dissolved completely. Warm water does make mixing easier, but is not necessary. 4. After mixing the calcium into your sprayer, mix in sugar. Manufacturer's recommendations are to add 200 grams (1/2 pound) per acre. More can be added for sandier soils. 5. Once the product is mixed, ensure it is agitated until applied. 6. Do not tank mix with herbicides. 7. The GSR products need to be applied in a manner that ensures direct soil contact. Ground spay with nozzles that provide complete area coverage are most effective. Calcium is not recommended for foliar spray. 8. As with any tank mixing, always jar test other products with the GSR Calcium before mixing into your sprayer. 9. Avoid use with humates, or carbon-based products. Application rates: 1. The manufacturer recommended rates are 45 grams of the product mixed into a minimum of 10 gallons per acre of clean water. More water can be used. 2. Always consult a professional crop consultant for dierections for specific crop varieties or excess/deficient mineral values on your soil tests Disclaimer: Manufacturer and distributor assume no responsibility for use of the product other than as a calcium deficiency. Soil testing and analysis is recommeneded. Application rates should be determined by a professional soil consultant |
|
Disclaimer: We are not Agronomists and have made no attempt to portray ourselves or our sales representatives as agronomists. Please use our website and services at your own risk. |